Multifunction Lever; Hazard Warning Switch; Keypad - Can-Am MAVERICK Sport MAX T Operator's Manual

3) Multifunction Lever

Low/High Beam Selection
219002128-004
1. Multifunction lever
When the multifunction lever is in the
middle position, the low beam is se-
lected.
Push the multifunction lever forward to
select high beam.
Pull back the multifunction lever to re-
turn to low beam.
NOTE: The lights automatically turn
on when the ignition switch is in the
ON position.
Headlight Flashing
To flash the high beams while in low
beams, pull on the multifunction lever.
Horn Activation
To activate the horn, push on the end
of the multifunction lever towards the
steering wheel.
Turn Signal Activation
To activate the LH turn signals, push
down the multifunction lever.
To activate the RH turn signals, push up
the multifunction lever.
Reposition the multifunction lever in
the middle position to stop the turn sig-
nals.

4) Hazard Warning Switch

The hazard warning switch is located
on the upper console.
219002128-005
1. Hazard warning switch
This switch operates all the turn signals
simultaneously. To be used when the
vehicle is stationary to indicate that the
vehicle is temporarily obstructing traf-
fic.
Press the hazard warning switch to
turn on.
When a trailer is connected and the
turn signals or hazards are activated,
the 1 symbol located on the lower por-
tion of the switch will blink.
NOTE: Hazard warning lights can be
activated even when the vehicle elec-
trical system is shut down.

5) Keypad

The keypad is located on the upper
console.
_______________
SECONDARY CONTROLS
65