Preparing To Ride; Riding Posture; Practice Exercises (Sm6 Model) - Can-Am SPYDER F3TM 2016 Operator's Manual

REQUIRED RIDING SKILLS AND PRACTICE EXERCISES
5
2
rmo2008-001-046_o
TYPICAL PARKING LOT
1. At least 30 m (100 ft)
2. At least 75 m (250 ft)
3. 12 m (40 ft)
4. 6 m (20 ft)
5. Open area
Even in a closed lot, be aware of poten-
tial traffic. Check to the front, sides
and rear before doing an exercise.
Also, watch out for children and ani-
mals.

Preparing to Ride

Know the location and operation of all
the vehicle controls. Refer to
INFORMATION
Perform the pre-ride inspection. Refer
PRE-RIDE INSPECTION
to
Always start and stop the engine ac-
cording to the instructions in
ING AND STOPPING THE ENGINE
BASIC PROCEDURES
_____
48
1
5
3
4
5
5
VEHICLE
section.
section.
START-
subsection.
SAFE OPERATING INSTRUCTIONS

Riding Posture

Good posture helps you maneuver the
vehicle more easily. Always keep both
hands and both feet in position so that
you can operate the controls easily.
The wrist should typically be aligned
straight with the arm (this position
helps you apply the amount of throt-
tle you want). Arms should be relaxed
and bent. Keep your back straight and
your head and eyes up. Keep both feet
on the pegs near the controls.
Never operate the vehicle, even for a
short distance, unless you are in the
proper riding posture.
rmo2015-008-901
RIDING POSTURE
Practice Exercises
(SM6 Model)
1) Revving the Engine and Using the
Engine Stop Switch
Purpose
– Become familiar with the sound of
the engine revving so you will not be
surprised during the exercises.
– Become familiar with using the en-
gine stop switch.
in
______