Can-Am SPYDER F3TM 2016 Operator's Manual page 130

HOW TO REPLACE FUSES AND LIGHTS
rmo2008-003-002
TYPICAL
3. Turn the bulb holder clockwise and
remove it from the connector.
rmo2008-001-086_a
TYPICAL
1. Turn clockwise
4. Pull bulb out of the holder as indi-
cated below.
rmo2008-001-087_a
TYPICAL
1. Pull out bulb
5. Insert a new bulb in the holder.
6. Properly reinstall t he parts in the re-
verse order of their removal.
F3-S Models
The position lights are built with LEDs
(light emitting diode) and this tech-
nology proved to be reliable. In the
______________
128
unlikely event they do not work,
have them checked by an authorized
Can-Am roadster dealer.
License Plate Light
1. Remove light cover.
rmr2015-133-009_a
TYPICAL
1. License plate light
2. Cover screw
2. Remove the bulb by pushing it in
and turning counterclockwise.
rmr2015-133-010_a
1. Light bulb
3. Install the new bulb by pushing and
turning it clockwise.
4. Confirm light operation.
5. Reinstall light cover.
Backup Light
Refer to procedure in
LIGHT — REAR (AUSTRALIAN AND
EUROPEAN MODELS)
TURN SIGNAL
subsection.