Operating In Reverse - Can-Am SPYDER F3TM 2016 Operator's Manual

NOTICE
If the parking brake is not
fully released before operating the
vehicle, brake pads will drag while
you are moving. This can damage
the brake system.
Stopping the Engine
SM6 Model
1. Shift into first gear.
2. Set the engine stop switch to OFF.
3. Engage the parking brake. The
brake locks in the depressed posi-
tion, and a scrolling message PARK
BRAKE will appear on the display.
4. Turn the key to OFF.
5. Before dismounting, check that the
parking brake is fully engaged. Hold
the clutch and rock the vehicle back
and forth.
WARNING
Always engage the parking brake.
The vehicle can roll if the parking
brake is not engaged and the trans-
mission is in neutral.
SE6 Model
1. Shift into neutral.
2. Set the engine stop switch to OFF.
3. Engage the parking brake. The
brake locks in the depressed posi-
tion, and a scrolling message PARK
BRAKE will appear on the display.
4. Turn the key to OFF.
NOTE: If the parking brake is not en-
gaged while the key is OFF, the park
brake indicator light will flash and a
beeper will sound.
5. Before dismounting, check that the
parking brake is fully engaged. Rock
the vehicle back and forth.
Always engage the parking brake.
The vehicle can roll if the parking
brake is not engaged, regardless
of what gear it is in. The clutch is
always disengaged when the vehi-
cle is stopped, so the transmission
will not hold the vehicle in place.
Pushing the Vehicle
CAUTION Avoid pushing the
vehicle on a slope. If you must push
the vehicle on a slope, take extra
care to stay within reach of the brake
pedal in case the vehicle starts to
roll.
To move the vehicle a short distance
without starting the engine:
1. While seated on the vehicle, push
down and hold the brake pedal.
2. Shift the transmission into NEU-
TRAL (SM6 model).
3. Disengage the parking brake.
4. Dismount on the right side of the ve-
hicle, keeping your foot on the brake
pedal.
5. Push the vehicle, using the brake as
needed.
CAUTION Only push from the
right side, so you can reach the brake
pedal. Stay clear of the hot exhaust
pipe.
When pulling the vehicle backward,
be careful that the front wheel does
not roll over your feet.
6. Remount the vehicle and park as
specified above.

Operating in Reverse

For safe operation in reverse, refer to
SAFE OPERATING INSTRUCTIONS
section.
_______________
BASIC PROCEDURES
WARNING
33