Parking Brake Switch - Can-Am SPYDER F3TM 2016 Operator's Manual

PRIMARY CONTROLS

7) Parking Brake Switch

The parking brake switch is located
on the LH side handlebar. It allows to
engage or release the electric parking
brake.
On SE6 models, there will be a 20 sec-
ond beep sound when stopping the en-
gine while the parking brake is not en-
gaged.
rmo2015-008-040_d
1. Parking brake switch
NOTE: To apply or release the parking
brake, the ignition key must be turned
ON.
NOTE: The battery voltage must be
at 11 V minimum to activate the park-
ing brake. If voltage is below 11 V, the
parking brake indicator lamp will turn
ON.
With the vehicle stopped, press the
parking brake switch to apply parking
brake. The brake indicator lamp will
flash.
NOTE: The parking brake cannot be
activated when the vehicle is above
10 km/h (6 MPH).
Check that the parking brake is fully en-
gaged. Hold the clutch (on SM6 mod-
els) and rock the vehicle back and forth.
______________
14
rmo2015-008-040_e
TYPICAL
1. Parking brake ON switch
To release parking brake, press and re-
lease switch and make sure brake indi-
cator lamp turns OFF.
NOTE: A beeping sound will be heard
if torque is applied and the parking
brake is not released.
rmo2015-008-040_f
TYPICAL
1. Parking brake OFF switch