Can-Am SPYDER F3TM 2016 Operator's Manual page 108

MAINTENANCE PROCEDURES
rmo2015-008-200_a
A. 10 m (33 ft)
90°
rmo2015-008-201_a
3. Trace 2 lines parallel to the ground
on the test surface as follows:
LINES ON THE TEST SURFACE
644 mm (25-23/64 in)
Line A
554 mm (21-13/16 in)
Line B
4. Have driver take place on the
driver's seat.
5. Select low beam.
6. Beam aiming is correct when the
top line of the headlight reflection is
between the marks.
rmo2015-008-778_a
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE (SINGLE HEADLAMP)
1. Top line
A. Mark at 644 mm (25-23/64 in) above ground
B. Mark at 554 mm (21-13/16 in) above ground
______________
106
above ground
above ground
Headlights Aiming Verification
(European, Australian and Japanese
Models)
1. Verify tires are correctly inflated.
SPECIFICATIONS
Refer to
2. Position vehicle 10 m (33 ft) in front
of a test surface as shown. Make
sure vehicle is on leveled ground.
rmo2015-008-200_a
A. 10 m (33 ft)
90°
rmo2015-008-201_a
3. Trace 4 lines parallel to the ground
on the test surface as follows:
LINES ON THE TEST SURFACE
Line A
Line B 618 mm (24-21/64 in)
564 mm (22-13/64 in)
Line C
Line D 514 mm (20-15/64 in)
4. Have driver take place on the
driver's seat.
5. Select high beam.
6. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
upper marks.
.
688 mm (27-3/32 in)