Getting Started; Unpacking And Inspection - Datamax Prodigy Operator's Manual

2

Getting Started

2.1 Unpacking and Inspection

Inspect the shipping container(s) for signs of being dropped, crushed or
punctured. If damage is evident, contact the carrier directly to specify
the nature and extent of the damage.
The Printer is packed in custom styrofoam packaging. The Printer itself
is enclosed in a plastic bag to reduce the chance of moisture damage
during shipping. After removing the Printer from this plastic bag,
remove any additional packing material from the Printer mechanism.
(This material is placed in the Printer mechanism to prevent vibration
during shipping).
The front door panel of the Printer is shipped in a separate bag and
needs to be installed on the front of the Printer.
To install the front panel, locate the two hinge pins on the left-hand side
of the Printer. Hold the panel vertically and perpendicular to the front
of the Printer, align the two hinge pins with the panel and lower the
panel into place.
________________________________________________________
__
Getting Started Page - 15