Setup And Self Test; Checking Voltage Selection - Datamax Prodigy Operator's Manual

3

Setup and Self Test

The Printer has a unique SETUP AND SELF TEST routine that should
be run after unpacking and physical inspection to ensure the Printer was
not damaged during shipment. The self test will save time and
familiarize you with the Printer's function that can be set, such as
temperature, print speed, and slew rate.
In the SETUP AND SELF TEST procedure, the Printer will be loaded
and tested with both types of media and ran in both print modes (Direct
& Thermal Transfer).

3.1 Checking Voltage Selection

The standard Printer is shipped in a configuration that allows it to be
connected to a properly grounded 115 VAC single-phase 50/60 Hz
outlet. The maximum current draw will not exceed 2 amps. The line
voltage should not fluctuate more than 10% and the Printer should be
connected to a properly grounded receptacle. The Printer has a small
sticker next to CJ1 (the power cord connection) that states the power
requirements.
________________________________________________________
__
Setup and Self Test Page - 21