Linking; Dmx Mode; Dmx Configuration; Dmx Addressing - ProLights PIXIE BEAM User Manual

• Press the UP/DOWN button to scroll the menu, select the Set, then press the ENTER button to enter the
next menu.
• Press the UP/DOWN button to scroll through the menu, select UI Set, and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select Mic Sens. and press ENTER to confirm.
• Press the UP/DOWN button to adjust the level of sensitivity of the microphone, and then press the
ENTER button to confirm your choice.
• Press the MODE/ESC button repeatedly to exit the menu and save changes.

3.8 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.9 DMX MODE

To enter the DMX mode, follow these steps:
• Press the MODE button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Connect, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select the DMX Address and press the ENTER key.
• Press the arrow keys to select the desired value (001-512). Press the ENTER key to confirm the setting.
• Press the MODE/ESC button repeatedly to exit the menu and save changes.

3.10 DMX CONFIGURATION

The PIXIE BEAM has 2 DMX channel configurations which can be accessed from the control panel.
• Press the MODE button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set, then press the ENTER button to enter the
next menu.
• Press the UP/DOWN button to scroll through the menu, select Users and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select User Mode and press ENTER to confirm
your choice.
• Use the UP/DOWN button to select the desired DMX channel configuration (Standard, Basic1), then press
the ENTER button to confirm your choice.
• Press the MODE/ESC button repeatedly to exit the menu and save changes.
The tables on page 14 show the mode of operation and their values DMX.
The unit is equipped with 3-pole XLR connections.

3.11 DMX ADDRESSING

For operation via light control unit with DMX512 protocol, is sufficient connect the controller to PIXIE
BEAM. To able to operate the PIXIE BEAM with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the PIXIE BEAM. The other functions of the light effect panel are
then automatically assigned to the following addresses. An example with the start address 33 is shown
below:
PIXIE BEAM
11