Linking; Dmx Operation; Dmx Addressing - ProLights LUMIPAR7IRTRI User Manual

10

3.9 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.10 DMX OPERATION

• Press the button MENU so many times until shows [3CH] or [7CH], and press the button ENTER to confirm.
• Press the button UP/DOWN to select the desired DMX address [d001 - d512].

3.11 DMX ADDRESSING

To able to operate the LUMIPAR7IRTRI with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the LUMIPAR7IRTRI. The other functions of the light effect panel are
then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of Start address
DMX channels (example)
3 33
7 33
DMX Address: 33
DMX512 Controller
LUMIPAR7 IRTRI
DMX Address Next possible start
occupied address for unit No. 1
33-35
33-39
DMX Address: 40
Example 7 DMX channels configuration (7-CH mode)
Next possible start
address for unit No. 2
36
40
DMX Address: 47
Next possible start
address for unit No. 3
39
47
DMX Address: 54
Fig.4
42
54
. . . . . . . . . . . .