Sound Mode; Manual Color; Dimmer; Linking - ProLights BATPAR12UTRI User Manual

10
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 SOUND MODE

In music mode, via its integrated microphone, the unit can be controlled by music with a clear rhythm in
the bass range. If the music control should not work optimally, increase the volume or reduce the distance
between the sound source and the light effect unit.
• Press the button MENU so many times until the display shows Snd.
• Using UP/DOWN button, select one of the modes Snd1 or Snd2.
• Press the button ENTER to confirm.
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
Sens
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) u0 - u100.
• Press the button ENTER to confirm.

3.7 MANUAL COLOR

This mode allows to combine the colors red, green and blue (r, g, b).
• Press the button MENU so many times until the display shows U-- , then press the button ENTER.
• Select the color r, g, b through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.8 DIMMER

• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times until
shows dIM, and press the button ENTER to confirm.
• Press the button UP/DOWN to select OFF - dIM1 - dIM2 - dIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.9 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit. Use standard DMX cables to daisy chain your units together via the DMX connector on the
rear of the units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.10 DMX CONFIGURATION

BATPAR12UTRI is equipped with different DMX configuration.
• Press the button MENU to select the desired DMX configuration (3CH - 8CH), then press the button ENTER.
• Press the button UP/DOWN to select the desider value (001 - 512), then press the button ENTER to con-
firm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
BATpAR12UTRi