Yamaha RX-V563 Owner's Manual page 97

• Remote control
Troubleshootmg
The remote control
does not work nor
function properly.
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The remote control code is not correctly
set.
The remote control functions within a maximum
range of 6 m (20
ft)
and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Set the remote control code correctly using "List of
remote control codes" at the end of this manual.
25
3
78
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
• Resetting the system
Use this feature to reset all the parameters of this unit to
the initial factory settings.
1
Press @SYSTEM OFF on the front panel to
set this unit to the standby mode.
2
Press and hold ®TONE CONTROL and
then press ®MAIN ZONE ON/OFF to turn
on this unit.
The advanced setup menu appears in the front panel
display.
3
Press @PROGRAM
<J
Ir>
to select "INIT.".
4
Press ®STRAIGHT repeatedly to select
"RESET".
Select "CANCEL" to cancel the initialization
procedure without making any changes.
5
Press ®MAIN ZONE ON/OFF to confirm
your selection and set this unit to the
standby mode.
Try setting another code for the same manufacturer 78
using "List of remote control codes" at the end of this
manual.
• This procedure completely resets all the parameters of this unit
including the "SET MENU" parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
,I,
~tjl~
To cancel the initialization procedure at any time without making
any changes, press
®STRAIGHT
repeatedly to select
"CANCEL" and then press
®MAlN ZONE ON/OFF.
93
En
I