Yamaha RX-V563 Owner's Manual page 42

Playback
• Audio information
You can combine a video image from a video source with
sound from an audio source. For example, you can enjoy
listening to classical music while viewing beautiful
scenery from the video source on the video monitor.
FORt1HT
SHt1PL I t·413
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
The number of samples per second taken from
a continuous signal to make a discrete signal.
Press the input selector buttons (@) control to
select a video source and then an audio source.
CHHt·H·4EL
The number of source channels in the input
signal (fronllsurroundlLFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as "3/2/0.1 ".
XU SIRIUS
c::J c::J
Audio sources
Video sources
BITF:HTE
FLHI3
The number of bits passing a given point per
second.
Flag data encoded in DTS, Dolby Digital, or
PCM signals that cue this unit to automatically
switch decoders.
• Video information
"---" appears when this unit cannot display the corresponding
information.
Resolution of the HDMI signals input or
output at the HDMI IN/OUT jacks of this
unit.
HDt1I RES.
HDt1 I SII3t·4HL
Type of the source video signals and the
video signals output at the HDMI OUT
jack of this unit.
~\ci<-:.
• You can also select "MULTI CH" as the audio source (see
page 36). Press @AMP and then press @MULTI CH IN.
• Set the "BGY" parameter in the "MULTI CH SET' menu to the
desired setting to select the default background video input
source of the MULTI CH INPUT sources (see page 72).
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Press ®AMP and then @MENU.
The top "SET MENU" display appears in the OSD.
HDt1 I ERf':OR
(Only when error
Is detected)
Error message for HDMI sources or
connected HDMI devices. See "HDMI
error and message" for details.
SET t'lENU
TOP flEflU
..
·~UTO
SETUP
• t'l~NU~L SETUP
• SI Gfl~L HlFO
"---" appears when this unit cannot display the corresponding
information.
["']/[T]:Up/Down
[EtHER]: Enter
HOMI error and message
DEI.) I CE OI.)ER
The number of the connected HDMI
components is over the limit.
2
Press @'i/ repeatedly to select "SIGNAL
INFO" and then press@ENTER.
The audio information about the input source appears
in the OSD.
HDCP ERROR
OUT OF f':ES.
HDCP authentication failed.
The connected monitor is not compatible
with the resolution of the input video signal.
3
Press @<] I
C>
to toggle between the audio
and video information displays.
4
Press @MENU again to exit from "SET
MENU".
38
En