Yamaha RX-V563 Owner's Manual page 95

Troubleshooling
After AUTO SETUP
W-l:0UT OF PHRSE
W-2:0UER 24M (80ft)
I.J-3: LEI.)EL ERROR
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the nearest speaker
and the furthest speaker is out of adjustable
range.
The difference of volume level among
speakers is excessive. (No level correction
is made.)
Check the speaker connections for proper
polarity (+ or -).
Bring the speaker closer to the listening
position.
If "SWFR:TOO LOUD" or "SWFR:TOO
LOW" appears, adjust the output volume of
the subwoofer.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
12
26,67
II
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again.
• If a warning message "W-I", "W-2", or "W-3" appears, corrections are made, but they may not be optimal.
• If an error message "E-9" occurs repeatedly, please contact a qualified Yamaha service center.
• iPod
:NCiijfA
In case of a transmission error without a status message appearing in the front panel and in the OSD, check the connection to your iPod
(see page 20).
Connec t er'r'or'
Unk nC'l.o,In i Pc,d
iPc,d connected
Disconnected
Unable to pla':ol
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly stationed in a
Yamaha iPod universal dock (YDS-IO,
sold separately) connected to the DOCK
tenninal of this unit, and the connection
between your iPod and this unit is
complete.
Your iPod was removed from a Yamaha
iPod universal dock (YDS-I 0, sold
separately) connected to the DOCK
tenninal of this unit.
This unit cannot play back the songs
currently stored on your iPod.
Tum off this unit and reconnect the Yamaha iPod
universal dock to the DOCK tenninal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a Yamaha iPod universal
dock (YDS-IO, sold separately) connected to the
DOCK terminal of this unit.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
20
20
91
En
•