Yamaha RX-V563 Owner's Manual page 54

XM Sate/ltte Radio tuning
,I,
~<il~
Before perfonning operations, press @XM to select "XM" as the
input source.
• All Channel Search mode
1
Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select"ALL CH
SEARCH".
2
Press @PRESETITUNING/CH
<l/I>
(or
@PRESET/CH !J./
\I)
repeatedly to search
for a channel within all channels.
• You can search for a channel quickly by pressing and holding
@PRESETITUNING/CH <J /
C>
(or @PRESET/CH
!1 /
'J).
• To display the XM Radio ID number displayed in the front
panel display, select channel "0".
3
Press @PRESETITUNING/CH
<l/I>
(or
@PRESET/CH!J./\I) repeatedly to change
the preset channel number (1 to 8).
,I,
~<il~
You can also select the preset channel number directly by
pressing the numeric buttons (I to 8) on the remote control.
• Direct Number Access mode
1
Press @SRCH MODE repeatedly to select
"ALL CH SEARCH" or "CAT SEARCH".
2
Press the numeric buttons (@) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons as shown below.
• Category Search mode
1
Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select "CAT SEARCH".
The display changes as follows.
2
3
Press ®CATEGORY (or @A-E/CAT.
<l/I»
repeatedly to change the channel category.
Press @PRESETITUNING/CH
<l/I>
(or
@PRESET/CH !J./
\I)
repeatedly to search
for a channel within the selected channel
category.
• I
't1'
< ..: _ : .
I
.>
{':·:'t'1··:·
•• I I ••
--1
t
1 ·-,
-
.::.
,I,
~<il~
You can search for a channel quickly by pressing and holding
@PRESETITUNINGICH <J /
C>
(or @PRESET/CH
!1 /
'if).
• Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see "Setting XM Satellite Radio preset channels"
on page 51.
,I,
~<il~
All preset channels (A I to E8) recalls "00 I Preview" by the initial
factory setting.
1
Press @SEARCH MODE (or @SRCH
MODE) repeatedly to select "PRESET
SEARCH".
2
Press ®CATEGORY (or @A-E/CAT.
<l/I»
repeatedly to change the preset channel
group (A to E).
50
En
t
'"
~<il~
• To enter a one-digit or two-digit channel number, press the
numeric buttons (@) and then press @ENT to confinn the
input number. Instead of pressing @ENT to tune into the
channel immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• Pressing a button other than the numeric buttons (@)or@ENT
cancels the Direct Number Access mode procedure.