Trim Rod Reassembly - Mercury 45 Jet 50-55 Service Manual

9. Secure reservoir to manifold using four screws.
Torque screws to 70 lb. in. (7.7 N·m).
a
a - Screw
10. Install "E" clip, lubricated O-rings and to manual
release valve.
a
c
a - "E" Clip
b - O-ring
c - Manual Release Valve
11. Insert manual release valve into manifold and
tighten snuggly. Back release valve out 3 or 4
turns allowing trim rod installation.
a - Manual Release Valve
b - Manifold
5C-34 - MID-SECTION
a
51193
b
51196
b
a
51194

Trim Rod Reassembly

1. Install lubricated O-rings and rod wiper to end
cap.
a
a - Rod Wiper
b - Inner O-ring
c - Outer O-ring
2. Secure trim rod in soft jawed vise as shown.
3. Slide end cap onto trim rod.
a - End Cap
c
b
51145
a
51146
90-8i7643R1 DECEMBER 1996