Trim Rod Installation
1. Place trim cylinder in soft jawed vise.
2. Fill trim cylinder three inches (76.2mm) from top
of cylinder using Quicksilver Power Trim and
Steering Fluid or; (ATF) Type F, FA or Dexron II.
3. Install lubricated O-ring to memory piston and
place into cylinder. Push piston down to level of
oil.
Memory piston must not contact end cap during
trim rod/end cap installation.
a - O-ring
b - Memory Piston
90-817643R1 DECEMBER 1996
b
a
51144
4. Install trim rod into cylinder.
5. Tighten end cap assembly to cylinder securely
using spanner wrench (1/4 in. x 5/16 in. long
pegs).
a - Spanner Wrench (P/N 91-74951)
6. Tighten manual release valve snuggly following
end cap installation.
51196
51145
MID-SECTION - 5D-25