Mercury 45 Jet 50-55 Service Manual page 295

4. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
a - Lower Cross Pin
5. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
a - Lower Dowel Pin
90-817643R1 DECEMBER 1996
6. Apply Special Lubricant (92-13872A1) to surface
of upper pivot pin, pivot pin bore and trim ram
bore.
NOTE: Install trim ram with cross hole located as
shown. If trim ram is installed reversed, the trim send-
er (if installed) will not operate.
51147
a - Pivot Pin
b - Pivot Pin Bore
c - Trim Ram Bore
d - Install Trim Ram As Shown
51148
b b
a
Cross Hole
Transom Side
Engine Side
MID-SECTION - 5D-27
c
51515
d