Power Trim System Components; Torque Specifications; Quicksilver Lubricants And Service Aids - Mercury 45 Jet 50-55 Service Manual

Power Trim System
Components
1 - Trim Rod
2 - Dowel Pin (Upper)
3 - Upper Pivot Pin
4 - Rod Wiper
5 - O-ring .671 in. I.D.
6 - Cylinder Cap
7 - O-ring 1.864 in. I.D.
8 - O-ring .614 in. I.D.
9 - Trim Rod Piston
10- Ball (5)
11- Spring Seat (5)
12- Spring (5)
13- Retaining Plate
14- Screw (5)
15- O-ring 1.600 in I.D. (Rod Piston)
16- O-ring 1.600 in. I.D. (Memory Piston)
17- Memory Piston
18- Trim Rod Cylinder
19- Screw (2)
20- O-ring .208 in I.D. (2)
21- Filter
22- O-ring .301 in. I.D.
23- Valve Seat
24- O-ring .364 in. I.D.
25- Ball
26- Spring Guide
27- Spring
28- Dowel Pin (2)
29- Reservoir
30- Fill Screw
31- O-ring .583 in. I.D.
32- Screw (4)
33- Washer (4)
34- O-ring 2.364 in. I.D.
35- Screw
36- Drive Shaft
37- Pump
38- O-ring .176 in. I.D. (2)
39- Dowel Pin
40- Manifold
41- O-ring .114 in. I.D.
42- O-ring .208 in. I.D.
43- O-ring .239 in. I.D.
44- Relief Valve
45- "E" Clip
46- Wire Harness
47- Cap
48- Washer
49- Grommet
50- Screw (4)
51- Screw
52- Reservoir Cap
53- O-ring 2.364 in. I.D.
54- Disk Foam Pad
55- Nut (2)
56- End Cap
57- Washer (.030 in. Thick) (2)
58- Washer, Thrust
59- Armature
60- Washer (.010 in. Thick)
61- Housing
62- O-ring
63- End Frame
64- O-ring .489 in. I.D.
65- Screw (2)
90-817643R1 DECEMBER 1996
NOTE: It is recommended that "ALL" O-rings be re-
placed when servicing tilt system.

Torque Specifications

a
35 lb. in. (4.0 N·m)
b 100 lb. in. (11.2 N·m)
c
70 lb. in. (7.9 N·m)
d 90 lb. in. (10.2 N·m)
e
25 lb. in. (2.8 N·m)
f 13 lb. in. (1.5 N·m)
Quicksilver Lubricants and Service
Aids
A
Loctite Grade "A" (271)
B
2-4-C Marine Lubricant (92-90018A12)
26153
MID-SECTION - 5B-3