Fig. 11 A200 Disassembled; Fig. 11A Locking Bar And Locking Pins, Engaged; Fig. 11B Locking Pin, Engaged - Otto Bock A200 Instructions For Use Manual

Fig. 11 A200 disassembled
Perform the steps listed above in reverse order to reassem-
ble the power wheelchair.
Ensure that the locking bar is pushed back into its proper
position (see Fig. 11a, Pos. 1) and both locking pins engage
correctly (see Fig. 11a, Pos. 2).
CAUTION
Risk of injury if the locking mechanism is not properly
engaged.
Check that the locking pins are properly engaged at both
sides on the outside of the base support. The bolts must be
clearly visible so that the frame cannot unexpectedly disen-
gage from the drive unit sustainer. (see Fig. 11a, Pos. 3).
A200
Fig. 11a Locking bar and locking pins, engaged
Fig. 11b Locking pin, engaged
Transportation and Storage
Ottobock 97
|