Otto Bock A200 Instructions For Use Manual page 110

Operation
Activating the drive-away lock:
1. With the control unit switched on, press and hold the
On/Off switch.
2. Once you hear a signal sound (approx. 1 sec.), release
the On/Off switch.
3. Move the joystick to the front until a signal sound is
heard.
4. Now move the joystick to the rear until a further signal
sound is heard.
5. A long beep confirms that the driving function has been
locked. The control unit then turns off.
The activation of the drive-away lock is indicated by a run-
ning light bar on the LED indicator "Speed Levels" after
switching the control unit on (see Table 3).
Display
LED running light
Speed level indicator
Table 3 Display of the drive-away lock on the control panel
110 Ottobock
|
Information
Drive-away lock
Deactivating the drive-away lock:
1. After switching on, the battery capacity indicator is off
and the LED indicator "Speed Levels" is in running light
mode.
2. Move the joystick to the front until a signal sound is
heard.
3. Now move the joystick to the rear until a further signal
sound is heard.
4. A long signal sounds to confirm that the driving function
has been unlocked and the LED indicator "Battery Ca-
pacity" is on.
Now the drive-away lock is deactivated and the wheelchair
can be driven.
INFORMATION
If the joystick is not moved correctly, the drive-away lock
remains activated. For a new deactivation of the drive-
away lock, the you must switch off the control unit. After-
wards you can switch on the power wheelchair again and
deactivate the drive-away lock.
A200