Installing The Aileron - Flap Servos; Installing The Spinner - Seagull Models EXTRA EA 300L Assembly Manual

EXTRA EA 300l - 1395mm
Battery

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
16
.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
1) Using a small weight (
works well
the wing as indicated.
2) Place the servo between the mounting
blocks and space it from the hatch. Use a pencil
to mark the mounting hole locations on the
blocks.
3) Use drill bit in a pin vise to drill the mouting
holes in the blocks.
Instruction Manual.

INSTALLING THE AILERON - FLAP SERVOS.

Servos.
Because the size of servos differ, you
) and string, feed the string through
Small weight.
Thread.
Weighted fuel pick-up