12.6.11 Exit motor (M7): Option
(1)
Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2)
Disconnect 1 connector, remove 1 screw,
and then take off the exit motor with the
bracket while sliding it toward the right.
(3)
Release the harness from harness clamp,
remove 2 screws, and then takeoff the exit
motor.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Bracket
Fig. 12-37
Exit motor
Fig. 12-38
12 - 23
Connector
Exit motor
Screw
Bracket
e-STUDIO182/212/242
FUSER / EXIT UNIT
12