Cis Case - Toshiba e-STUDIO182 Service Manual

Notes:
1. When installing the CIS unit, be sure to
pass the flat harness through the harness
holder of the CIS case.
2. Be sure to pull the flat harness so that it is
not warped.
6.7.8

CIS case

(1) Take off the CIS unit.
P.6-21 "6.7.7 CIS unit (CIS)"
(2) Remove 1 screw and take off the belt
stopper.
Note:
When installing the belt stopper, install it so
that the protrusion of the stopper fits in the V-
groove on the inside of the CIS unit drive
belt-1.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Harness holder
Fig. 6-31
Flat harness
Fig. 6-32
Belt stopper
Fig. 6-33
6 - 23
CIS unit
drive belt-1
e-STUDIO182/212/242
SCANNER
6