Bypass Feed Copying; Interruption Copying - Toshiba e-STUDIO182 Service Manual

4.2.4

Bypass feed copying

1. Insert a sheet of paper into the bypass tray.
→ Bypass paper sensor ON
- Bypass feed priority state.
2. Press the [START] button
→ "READY" → "COPYING"
→ CIS LED ON
→ Scan motor ON → CIS unit move forward
→ Polygonal motor rotates in high speed
→ Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3. Bypass feeding
→ Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
→ Bypass pickup solenoid ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
→ Paper reaches the registration roller
→ Aligning operation
→ After a certain period of time, the bypass pickup solenoid OFF
4. Hereafter, the operation 3) through 6) of
4.2.5

Interruption copying

1. Press the [INTERRUPT] button
→ LED "INTERRUPT" ON
→ Copying operation in progress is temporarily stopped. CIS unit return to appropriate positions
→ "Job interrupted" is displayed
→ Automatic density and reproduction ratio 100% are set (The set number remains the same)
2. Select the desired copy condition
3. After the interruption copying is finished:
→ LED "INTERRUPT" OFF by pressing the [INTERRUPT] button
→ "READY to resume job" is displayed
4. Press the [START] button
→ The copying operation before the interruption is resumed
e-STUDIO182/212/242
GENERAL OPERATION
P.4-3 "4.2.3 Drawer feed copying" is repeated.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 4