4.2
Description of Operation
4.2.1
Warming-up
1. Initialization
Power ON
→ Heater lamp ON
→ "Please wait" is displayed
→ Fan motors ON
→ Initialization of scanning system
-
The CIS unit moves to the home position.
-
The CIS unit moves to the peak detection position.
-
The LED of CIS is turned ON.
-
Peak detection (white color is detected by the shading correction plate)
-
The LED of CIS is turned OFF.
-
The CIS unit moves to the home position.
→ "READY (WARMING UP)" is displayed
2. Pre-running operation (Only when the temperature is at 16 °C or less)
The pre-running operation is started when the temperature of the fuser roller surface reaches a
certain temperature.
→ The main motor is turned ON
-
Fuser roller rotated.
-
Drum rotated.
→ Pre-running operation stops after 15 seconds
3. When the surface temperature of the fuser roller becomes sufficient for fusing,
→ "READY" is displayed
4.2.2
Ready state (ready for copying)
Buttons on the control panel enabled
→ When no button is pressed for a certain period of time,
- Set number "1" is displayed. Equipment returns to the normal ready state.
e-STUDIO182/212/242
GENERAL OPERATION
© 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 2