10.7.8
Drum
(1)
Take off the main charger.
P.10-13 "10.7.4 Main charger"
(2)
Rotate the lever while pushing its latch and
pull it out.
(3)
Take off the drum.
Notes:
1. Be careful not to touch, spit or scratch the
drum surface.
2. Avoid direct light. Place the drum in a
dark place immediately after taking off.
3. Be careful not to touch or scratch the
edge of the cleaning blade.
10.7.9
Drum cleaning blade
(1)
Take off the drum.
P.10-15 "10.7.8 Drum"
(2)
Remove 2 screws and take off the drum
cleaning blade.
Note:
Be careful not to touch or scratch the edge of
the drum cleaning blade.
10.7.10 Drum separation finger
(1)
Take off the drum.
P.10-15 "10.7.8 Drum"
(2)
Take off 2 drum separation finger units by
removing 1 screw each.
Note:
When replacing the drum separation fingers,
make sure that the drum has been taken off
first since the fingers may scratch the drum
surface.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Lever
Fig. 10-22
Drum cleaning blade
Fig. 10-23
Drum separation finger unit
Fig. 10-24
10 - 15
Drum
e-STUDIO182/212/242
DRUM RELATED SECTION
10