(3)
Disconnect 2 connectors, remove 1 screw,
and then take off the fuse PC board by lifting
it up.
2.6.4
Paper feed controller PC board (PFC)
Note:
This paper feed controller PC board is optional for NAD, CND and MJD.
(1)
Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2)
Disconnect 2 connectors, remove 4 screws,
and then take off the paper feed controller
PC board and mylar sheet.
Notes:
•
If the ADU (optional) is installed,
disconnect 2 connectors of the ADU with
other connectors at the same time before
taking off the paper feed controller PC
board.
•
If the PFP (optional) is installed,
disconnect 2 connectors of the PFP with
other connectors at the same time before
taking off the paper feed controller PC
board.
e-STUDIO182/212/242
OUTLINE OF THE MACHINE
Fuse PC board
Connector ( ADU )
Connector ( PFP )
Connector
© 2009 TOSHIBA TEC CORPORATION All rights reserved
2 - 24
Connector
Fig. 2-28
Mylar
Paper feed controller
PC board
Fig. 2-29