Registration Sensor (S4) - Toshiba e-STUDIO182 Service Manual

9.5.20

Registration sensor (S4)

(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
(3) Take off the damp heater unit or dummy
plate.
P.9-18 "9.5.10 Damp heater unit (DH3) /
Dummy plate"
(4) Take off the registration roller (metal).
P.9-23 "9.5.17 Registration roller (metal)"
(5) Remove 1 screw.
(6) Take off the registration guide while lifting it
up. Release the latch and take off the drawer
detection switch bracket.
Note:
Be careful not to break the harness which
connects the registration guide unit with the
drawer detection switch when taking off the
unit.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Harness clamp
Fig. 9-52
Fig. 9-53
Registration guide unit
Fig. 9-54
9 - 25
Connector
Screw
Drawer detection
switch bracket
e-STUDIO182/212/242
PAPER FEEDING SYSTEM
9