Fortinet fortivoice Administrator's Manual page 175

Figure 59: PRI trunks (200D-T)
GUI field
Enabled
Name
Status
Type
To add a T1/E1 voice circuit trunk
1. Go to Trunks > PRI > PRI.
2. Click New.
3. Configure the following:
Figure 60: Adding a T1/E1 trunk
GUI field
PRI Setting
Fortinet Technologies Inc.
Description
Select to activate the trunk.
The name of the trunk.
The trunk statuses, including:
• In service: The trunk is currently in use.
• Not activated: The trunk is not enabled.
• Idle: The trunk is not in use.
• Unavailable: The trunk is not reachable.
• Conflict: The trunk conflicts with another one.
• Alarm detected: There is a problem with the trunk.
• Admin down: The trunk is disabled.
The trunk type: digital or analog.
Description
Name The name of this trunk. This is view only.
Page 175 FortiVoice Enterprise Phone System 4.0.0 Administration Guide