Fortinet fortivoice Administrator's Manual page 17

Bits per second
Data bits
Parity
Stop bits
Flow control
8. Press Enter.
The terminal emulator connects to the CLI and the CLI displays a login prompt.
9. Type admin and press Enter twice. (In its default state, there is no password for this
account.)
The CLI displays a prompt, such as:
FortiVoice #
10.Type admin and press Enter twice. (In its default state, there is no password for this
account.)
The CLI displays the following text:
Type ? for a list of commands.
You can now enter commands. For information about how to use the CLI, including how to
connect to the CLI using SSH or Telnet, see the
The following procedure uses PuTTY. Steps may vary with other SSH clients.
To connect to the CLI using an SSH connection
1. On your management computer, configure the Ethernet port with the static IP address
192.168.1.2 with a netmask of 255.255.255.0.
2. Using the Ethernet cable, connect your computer's Ethernet port to the FortiVoice unit's
port1.
3. Verify that the FortiVoice unit is powered on.
4. On your management computer, start your SSH client.
5. In Host Name (or IP Address), type 192.168.1.99.
6. In Port, type 22.
7. From Connection type, select SSH.
8. Select Open.
The SSH client connects to the FortiVoice unit.
The SSH client may display a warning if this is the first time you are connecting to the
FortiVoice unit and its SSH key is not yet recognized by your SSH client, or if you have
previously connected to the FortiVoice unit but it used a different IP address or SSH key. If
your management computer is directly connected to the FortiVoice unit with no network
hosts between them, this is normal.
9. Click Yes to verify the fingerprint and accept the FortiVoice unit's SSH key. You cannot log in
until you accept the key.
The CLI displays a login prompt.
Fortinet Technologies Inc.
9600
8
None
1
None
Page 17 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
FortiVoice CLI Reference.