Shutter Speed; Remaining Disc Capacity; Remaining Clips Display - Sony PDW-850 Operation Manual

i Shutter speed
Indicates the shutter speed or the shutter mode.
However, if the SHUTTER selector (see page 13)
is set to OFF, nothing is displayed.
For details of the displayed shutter speed, see
"Setting the Electronic Shutter" (page 57).
j Operation/alarm message display area
For details, see "Operation/alarm messages"
(page 240).
k Audio level
Indicates the level of audio channel 1 and channel
2. The peak indication of the VDR level meter is
related as follows to the audio level.
1
2
-52 -28
3
1 Audio channel 1 level indicator
2 Audio channel 2 level indicator
3 VDR level meter indicator
The segment colors change from gray to white at
or above the AU REF LEVEL set on the AUDIO-
2 page of the MAINTENANCE menu. This
setting does not affect the relationship between
the number of lit segments and the audio levels.
The example in the above figure shows the colors
when AU REF LEVEL is set to –20 dB.
-20 -12 -8 (dB)
l Remaining disc capacity
Indicates the remaining recording time (in
minutes) of the disc.
Examples of remaining recording time indication
Indication Remaining recording
time
. .
. .
. .
110 < 120 to 110 minutes
100 < 110 to 100 minutes
90 < 100 to 90 minutes
90 - 85 90 to 85 minutes
85 - 80 85 to 80 minutes
. .
. .
. .
20 - 15 20 to 15 minutes
15 - 10 15 to 10 minutes
10 - 5 10 to 5 minutes
5MIN (flash) 5 minutes
4MIN (flash) 4 minutes
3MIN (flash) 3 minutes
2MIN (flash) 2 minutes
1MIN (flash) 1 minute
0MIN (flash) 0 minutes
Note
During shooting in special modes, such as Interval Rec,
the indicated remaining disc time may differ from the
time which can be actually shot and recorded.
m Remaining clips display
Displays the remaining number of clips that can
be recorded. The display flashes once per second
when the number of remaining clips is less than
10.
n Iris setting/auto iris override
Indicates the F value (iris setting) of the lens.
Auto iris override is shown by an indicator made
up of two segments each on the upper and lower
sides.
For details, see "Changing the Reference Value for
Automatic Iris Adjustment" (page 59).
Locations and Functions of Parts and Controls
31