Setting The Color Temperature Manually - Sony PDW-850 Operation Manual

Notes
• WPS does not support the following.
- Ad hoc mode
- IEEE 802.1x
• The access point must support WPS.
• In addition to the settings made here, you must also
make network settings on the NETWORK page of the
MAINTENANCE menu.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the WPS page of the
MAINTENANCE menu and then press
the MENU knob.
See "Basic menu operations" (page 184) for
more information about menu operations.
2
Select "ENABLE" and then press the
MENU knob.
The screen changes to the operation screen.
M24 WPS
Wi-Fi
WPS MODE
WPS START
WPS STATUS
3
Set WPS MODE to one of the following.
ONE PUSH: Connect using the one push
method
PIN CODE: Connect using the PIN code
entry method.
When you select "PIN CODE"
A PIN item appears. Execute "UPDATE" in
that item to display a PIN code for this unit.
4
Select "WPS START" and then press
the MENU knob.
WPS setup starts. During execution, the
progress and results appear after WPS
STATUS.
SCANNING: Scanning for an access point
OK: Detection successful
NG: Detection failed
When execution finishes, the screen changes
to the ACCESS PNT page.
206
Adjustments and Settings from Menus
TOP
: ENABL
: ONE PUSH
: EXEC
: -----
5
Select the desired connection
destination from the detected access
points, and then press the MENU knob.
Setting the color temperature
manually
You can manually adjust the value of the white
balance by setting the color temperature.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the WHITE page of the PAINT
menu, and press the MENU knob.
For details on menu operations, see "Basic
menu operations" (page 184).
2
Select the desired item, and press the
MENU knob.
You can set the following items on the
WHITE page.
Item Description
COLOR Sets the color temperature for
TEMP <A> the desired value. Adjust the
value while looking at the real
image because error tends to be
bigger for adjustment of high
color temperature.
C TEMP Adjusts the value more
BAL <A> precisely when the color
temperature adjustment
through COLOR TEMP is not
satisfactory.
R GAIN <A> Changes only the value of R
GAIN.
B GAIN <A> Changes only the value of B
GAIN.
The above table shows the adjustment of the
white balance of channel A. Items followed
by <B> are used to adjust the white balance
of channel B.
3
Turn the MENU knob to change the
setting, and press the MENU knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.