Sony PDW-850 Operation Manual page 130

To change the serial numbers of clip
names using planning metadata
You can change the serial numbers that are added
to clip names that use planning metadata.
See page 108 for more information about GUI
screen operations.
1
Display the Disc Menu.
2
Select Planning Clip Name Suffix
(change the serial number added to clip
names created by using planning
metadata), and then press the SET/
S.SEL button or MENU knob.
The Planning Clip Name Suffix screen
appears.
3
Press the left- or right-arrow button to
select a digit to change.
4
Press the up- or down-arrow button, or
turn the MENU knob to change the
digit.
5
Repeat steps
6
Press the SET/S.SEL button or the
MENU knob.
"OK" is selected.
7
Press the SET/S.SEL button or the
MENU knob.
To clear planning metadata
See page 108 for more information about GUI
screen operations.
1
Display the Disc Menu.
2
Select "Clear Planning Metadata", and
then press the SET/S.SEL button or the
MENU knob.
A message appears asking you to confirm
that you want to clear the planning metadata.
130
Disc Operations
3 4
and as required.
3
Select "OK", and then press the SET/
S.SEL button or the MENU knob.
The planning metadata is cleared from this
unit's memory.
To switch the title display in the LCD
monitor and viewfinder
When planning metadata is loaded into this unit,
you can select the format of the title to display in
the LCD monitor and viewfinder.
See page 108 for more information about GUI
screen operations.
1
Display the Disc Menu.
2
Select "Settings", and then press the
SET/S.SEL button or the MENU knob.
3
Select "Planning Clip Name in Clip
Info. Area", and then press the SET/
S.SEL button or the MENU knob.
See page 28 for more information about the
Clip Info. Area.
4
Select one of the following, and then
press the SET/S.SEL button or the
MENU knob.
ASCII Clip Name: Display the ASCII
format title (see page 91).
Clip Name: Display the UTF-8 format title
(see page 91).
To display clip names in the clip
information area in the viewfinder
1
Display the Disc Menu.
2
Select "Settings", and then press the
SET/S.SEL button or the MENU knob.
3
Select "Planning Clip Name Display"
(whether to display the clip name in the
viewfinder screen), and then press the
SET/S.SEL button or the MENU knob.
4
Select "Enable", and then press the
SET/S.SEL button or the MENU knob.
Clip information is always shown in the warning
indicator area of the LCD monitor if the LCD
monitor is set to status display.