Setting Power Saving Functions - Sony PDW-850 Operation Manual

switches, each time the switch is pressed toggles
the function on or off.
When another type of menu item is assigned,
pressing the switch displays the item and its
setting value on the viewfinder screen.
You can then change the setting by pressing and
turning the MENU knob.
The viewfinder screen display disappears
approximately three seconds after the last
operation.

Setting power saving functions

You can limit the function of some output
connectors to save power consumption.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the POWER SAVE page of the
OPERATION menu, and press the
MENU knob.
For details on menu operations, see "Basic
menu operations" (page 184).
2
Select the desired item, and press the
MENU knob.
You can set the following items on the
POWER SAVE page.
Item Description
ETHERNET/ Enables or disables the
USB network connector and USB
connector.
REC AUDIO Puts the AUDIO OUT
OUT connectors in EE or SAVE
mode.
TEST OUT Switches the TEST OUT
SAVE connector power saving
function on and off.
ON: No signals are output if
OFF: Signals are always
Wi-Fi Enables or disables the
wireless LAN function.
a) The unit must be powered off and on again to
enable changes to this setting.
a cable is not
connected.
output, regardless of
whether a cable is
connected.
3
Turn the MENU knob to select the
desired setting, and press the MENU
knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.
Setting up a wireless LAN
You can install the optional CBK-WA01 Wi-Fi
Adaptor in this unit, and set up a wireless LAN as
explained in this section.
When you connect this unit to a computer over a
network, you can make the settings explained here
from a Web menu. For details, refer to the operation
manual supplied with the optional CBK-WA01 Wi-Fi
Adaptor.
Notes
• For information about connecting to a wireless LAN,
refer to the operation manual supplied with the
optional CBK-WA01 Wi-Fi Adaptor.
• Even when the optional CBK-WA01 Wi-Fi Adaptor is
installed in this unit, the message "NO Wi-Fi
ADAPTER!" may appear if you attempt to set up a
wireless LAN immediately after powering the unit on.
If this occurs, wait for a while and try again.
• If the message "IEEE802.1X IS ENABLED!" appears
when you change the settings, execute NET CFG
RESET on the NETWORK 2 page of the
MAINTENANCE menu and then try again.
• The proxy data recording function is disabled
automatically whenever you enable the wireless LAN
connection function.
Before starting, set ETHERNET/USB and Wi-Fi
on the POWER SAVE page of the OPERATION
menu to "ENABL".
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the Wi-Fi page of the
MAINTENANCE menu, and then press
the MENU knob.
See "Basic menu operations" (page 184) for
more information about menu operations.
Adjustments and Settings from Menus
203