Important Notes On Operation - Sony PDW-850 Operation Manual

Appendix
Important Notes on
Operation
Use and storage
Do not subject the unit to severe shocks
The internal mechanism may be damaged or the
body warped.
Do not cover the unit while operating
Putting a cloth, for example, over the unit can
cause excessive internal heat build-up.
After use
Always turn off the POWER switch.
Before storing the camcorder for a long period
Remove the battery pack.
Shipping
• Remove the disc before transporting the unit.
• If sending the unit by truck, ship, air or other
transportation service, pack it in the shipping
carton of the unit.
Care of the unit
Remove dust and dirt from the surfaces of the
lenses or optical filters using a blower.
If the body of the unit is dirty, clean it with a soft,
dry cloth. In extreme cases, use a cloth steeped in
a little neutral detergent, then wipe dry. Do not
use organic solvents such as alcohol or thinners,
as these may cause discoloration or other damage
to the finish of the unit.
In the event of operating problems
If you should experience problems with the unit,
contact a Sony representative.
Use and storage locations
Store in a level, ventilated place. Avoid using or
storing the unit in the following places.
• In excessive heat or cold (operating temperature
range: –5°C to +40°C (+23°F to +104°F))
• Remember that in summer in warm climates the
temperature inside a car with the windows
closed can easily exceed 50°C (122°F).
• In damp or dusty locations
• Locations where the unit may be exposed to rain
• Locations subject to violent vibration
• Near strong magnetic fields
• Close to radio or TV transmitters producing
strong electromagnetic fields.
• In direct sunlight or close to heaters for
extended periods
To prevent electromagnetic interference from
portable communications devices
The use of portable telephones and other
communications devices near this unit can result
in malfunctions and interference with audio and
video signals.
It is recommended that the portable
communications devices near this unit be
powered off.
Note on laser beams
Laser beams may damage the CCDs.
If you shoot a scene that includes a laser beam, be
careful not to let the laser beam be directed into
the lens of the camera.
Condensation
If the unit is suddenly taken from a cold to a warm
location, or if ambient temperature suddenly
rises, moisture may form on the outer surface of
the unit and/or inside of the unit. This is known as
condensation. If condensation occurs, turn off the
unit and wait until the condensation clears before
operating the unit. Operating the unit while
condensation is present may damage the unit.
Do the following to prevent this from happening.
• When you move or operate the camcorder in an
environment where condensation may form, be
sure to load a disc in advance and close the disc
compartment lid.
For details, see "Loading and unloading a disc"
(page 69).

Important Notes on Operation

245