Installing The Intrusion Switch - Dell PowerEdge R230 Owner's Manual

Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Using the plastic scribe, slide the intrusion switch out of the intrusion switch slot.
Figure 14. Removing and installing the intrusion switch
1. intrusion switch
3. intrusion switch cable
5. cable routing clip (2)
Next steps
1. Install the intrusion switch.
2. Follow the procedure listed in
Related Tasks

Installing the intrusion switch

Installing the intrusion switch
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
50
After working inside your system
Safety instructions.
Before working inside your
2. intrusion switch slot
4. intrusion switch connector on the
system board
system.