Dell PowerEdge R230 Owner's Manual page 12

Item Indicator, Button, or
Connector
2 NMI button
3 System identification
button
4 Video connector
5 Hard drives
6 Diagnostic indicators
7 USB connectors
8 Information tag
9 Optical drive
(optional)
12
Icon Description
NOTE: On ACPI-compliant operating
systems, turning off the system using
the power button causes the system to
perform a graceful shutdown before
power to the system is turned off.
Enables you to troubleshoot software and
device driver errors when running certain
operating systems. This button can be
pressed by using the end of a paper clip.
Use this button only if directed to do so by
qualified support personnel or by the
operating system's documentation.
Enables you to locate a particular system
within a rack. The identification buttons are
on the front and back panels. When one of
these buttons is pressed, the LCD panel on
the front and the system status indicator on
the back flash until one of the buttons is
pressed again.
Press the button to turn the system ID on or
off. If the system stops responding during
POST, press and hold the system ID button
for more than five seconds to enter BIOS
progress mode.
To reset the iDRAC (if not disabled in F2
iDRAC setup) press and hold the button for
more than 15 seconds.
Enables you to connect a display to the
system.
Enables you to install up to two 3.5-inch
cabled hard drives.
The diagnostic indicator glows to display
error status. For more information, see
Diagnostic indicators.
Enable you to connect USB devices to the
system. The port is USB 2.0-compliant.
Contains system information such as service
tag, NIC, MAC address for your reference.
The information tag is a slide-out label panel.
Enables you to install an optional slim SATA
DVD-ROM drive or DVD+/-RW drive.