Hard Drive Backplane; Removing The Hard Drive Backplane - Dell PowerEdge R230 Owner's Manual

4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related Tasks
Removing the expansion card riser
Installing the expansion card riser

Hard drive backplane

Systems with four 3.5-inch hot swappable SAS or SATA hard drives support a hard drive backplane.

Removing the hard drive backplane

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives
from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can replace them in the same locations.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove all the hard drives.
4. Disconnect the SAS/SATA data, signal, and power cable(s) from the backplane.
Steps
Press the release tabs and lift the hard drive backplane out of the chassis.
Safety instructions.
Before working inside your system.
101