Dell PowerEdge R230 Owner's Manual page 100

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be
performed only by Dell certified service technicians.
Steps
1. Locate the battery socket. For more information, see
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2. Use a plastic scribe to pry out the system battery as shown in the following illustration:
Figure 44. Removing the system battery
1. plastic scribe
3. securing tabs
3. Install a new system battery by holding the battery with the "+" sign facing up and slide it under the
securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 45. Installing the system battery
1. positive side of the battery connector
Next steps
1. Install the expansion card riser.
2. Follow the procedure listed in
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
100
System board jumpers and
After working inside your
2. positive side of the battery connector
2. battery connector
system.
connectors.