Removing A Hot Swappable Hard Drive From A Hard Drive Carrier - Dell PowerEdge R230 Owner's Manual

Hide thumbs Also See for PowerEdge R230:
Table of Contents

Advertisement

Next steps
If you are not replacing the hard drive immediately, insert a hard drive carrier blank in the empty hard
drive slot, or install a hard drive carrier.
Related Tasks
Removing the optional front bezel
Installing a 3.5-inch hot swappable hard drive carrier blank
Installing a hot swappable hard drive carrier
Installing the optional front bezel

Removing a hot swappable hard drive from a hard drive carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: Hot swappable hard drives are supplied in hot swappable hard drive carriers that fit in the
hard drive slots.
1.
Keep the Phillips #2 screwdriver ready.
2.
Remove the hard drive carrier from the system.
Steps
1.
Remove the screws from the side rails on the hard drive carrier.
2.
Lift the hard drive out of the hard drive carrier.
Figure 23. Removing and installing a hot swappable hard drive into a hard drive carrier
1.
screw (4)
3.
hard drive carrier
2.
hard drive
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents