Installing A Cabled Power Supply Unit; System Battery; Replacing The System Battery - Dell PowerEdge R230 Owner's Manual

3. P2 cable connector
5. standoff
Next steps
1. Install the cabled PSU.
2. Follow the procedure listed in
Related Tasks

Installing a cabled power supply unit

Installing a cabled power supply unit
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Slide the power supply unit (PSU) into the PSU slot.
2. Align the screw hole on the PSU with the standoff on the chassis.
3. Tighten the screw to secure the PSU to the chassis.
4. Connect all the power cables to the system board, hard drives, and optical drive.
Next steps
Follow the procedure listed in

System battery

Replacing the system battery

Prerequisites
1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove the expansion card riser.
4. Keep the plastic scribe ready.
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. For more
information, see the safety information that shipped with your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
After working inside your
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
4. P1 cable connector
6. P3 cable connector
system.
system.
system.
system.
99