Removing The Led Control Panel Assembly - Dell PowerEdge R230 Owner's Manual

3. Push the control panel toward the chassis until it snaps into place.
Next steps
Follow the procedure listed in

Removing the LED control panel assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Disconnect the cables connected to the control panel module.
CAUTION: Do not use excessive force when removing the control panel as it can damage the
connectors.
Steps
1. For cabled hard drive chassis, perform the following steps:
a. Remove the screw(s) that secure the LED panel to the chassis.
b. Remove the LED panel.
2. Remove the screws that secure the control panel board to the chassis.
3. Lift the control panel board away from the chassis.
Figure 50. Removing and installing the LED module—four cabled hard drive chassis
1. LED module
After working inside your
Safety instructions.
Before working inside your
system.
system.
2. screw (2)
107