Manual - Electrolux 266200 Installation And Operation Instructions Manual

4.4 MANUAL

After SWITCHING THE OVEN ON the following MANUAL cooking
mode screen appears:
Drop-down "CONTROLS MENU":
Manual

Programs
Cleaning
Settings
Manual
Phase
1 of 1
3
48°
0:30
0:30
START
"DRAWER" drop-down menu
with Utilities in several items of the CONTROLS MENU
To set a cooking cycle, select the required CYCLE:
HOT AIR
and set:
- HUMIDIFICATION (touch CYCLE button)
- TEMPERATURE (touch the bar
- TIME (touch the bar
or CORE PROBE (touch the bar
When the fi rst cooking phase is set with core probe, it will last
at least one minute.
In this way a cooking cycle has been set; now, just close the door
and touch START to start the Cycle.
The PREHEATING stage starts, after which the message "LOAD"
appears, indicating to place food in the oven; close the door to
start cooking.
In case of AUTOMATIC START, just close the door to automati-
cally start the cycle.
After about 10 seconds the following Cooking in Progress screen
will appear:
Cooking PHASES (1 of 1)
Cooking CYCLES
Set HUMIDIFICATION
Set
TEMPERATURE
Current TIME
* In PROGRAMMED mode, the word "Convection" will be replaced
Set TIME
by the name of the Program or Recipe in progress (e.g. Chicken)
This fi gure (for information) shows nearly all the possible cases;
Start CYCLE but only those concerned are
Touch this screen to return to the MANUAL control Settings.
INFORMATION
Any setting already made can be modifi ed and the Cooking Cycle
AREA can be stopped by touching STOP for a few seconds.
The SKIP COMPARTMENT PREHEATING function also appears
with the respective symbol
preheating for particular types of cooking.
The previous description regarded setting a cooking Cycle. Now,
this will enable setting others in a more complex way, by adding
(touch)
the other functions made available.
)
)
and then )
43
Phase 2/3
Convection
3
160°
2:17
2:30
presented.
next to the STOP button, to skip
STOP
GB
Cooking PHASE (2 of 3)
Hot Air cycle * in progress
HUMIDIFICATION in progress
Set TEMPERATURE
TIME in progress
set TIME
HALF SPEED in progress
(example)