Rj45 Sensor Cable - NTI ENVIROMUX Series Installation Manual

NTI ENVIROMUX TEMPERATURE/HUMIDITY SENSOR ATTACHMENT

RJ45 Sensor Cable

The CAT5 connection cable between the ENVIROMUX and connected external sensors is terminated with RJ45 connectors and
must be wired according to the EIA/TIA 568 B industry standard. Wiring is as per the table and drawing below.
that connect to "RJ45 Sensor" ports (ENVIROMUX-16(U)/xD) are all designed to use cables wired to this standard.
Pin Wire Color
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
TRADEMARK
ENVIROMUX is a registered trademark of Network Technologies Inc in the U.S. and other countries.
COPYRIGHT
Copyright © 2008, 2016 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored
in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
CHANGES
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the
right to make changes in the product design without reservation and without notification to its users.
Pair
2
2
3
1
1
3
4
4
7
Pair 3
Pair 2 Pair 1
Pair 4
T
T R R T R T R
1 2 3
4 5 6 7 8
+ - +
- + - + -
(View Looking into RJ45 Socket)
The sensors
MAN215 REV 2/12/2016