KH2508
/ KH2516
A
A
Stacking and Rack Mounting
The KH2508
/ KH2516
A
the front or rear of the rack. The following sections take you through the
procedures for each method.
Note: 1. Allow at least 5.1 cm on each side for adequate ventilation and
12.7 cm at the rear for power cord and cable clearance.
2. The standard rack mount kit does not include rack mount screws or
cage nuts. If you need additional rack mount screws or cage nuts,
contact your rack dealer.
Stacking
The KH2508
/ KH2516
A
can safely support its weight plus the weight of its attached cables. To place the
KH2508
/ KH2516
A
the backing material from the bottom of the rubber feet that came with this
package, and stick them onto the switch's bottom panel at the corners, as
shown in the diagram, below:
12
User Manual
can be stacked on the desktop or rack mounted at
A
can be placed on any appropriate level surface that
A
, or to stack units if you are daisy chaining them, remove
A