Stacking And Rack Mounting; Stacking - ATEN CS1768 User Manual

8-port usb dvi kvm switch

Hide thumbs Also See for CS1768:

Table of Contents

CS1768 User Manual

Stacking and Rack Mounting

The CS1768 can be stacked on the desktop or rack mounted at the front or rear

of the rack. The following sections take you through the procedures for each

method.

Note: 1. Allow at least 5.1 cm on each side for adequate ventilation and

12.7 cm at the rear for power cord and cable clearance.

2. The standard rack mounting kit does not include screws or cage nuts.

If you need additional screws or cage nuts, contact your rack dealer.

The CS1768 can be placed on any level surface that can safely support its

weight and the weight of the attached cables. Make sure that the surface is

clean and free of any materials that can block the exhaust vents or otherwise

interfere with normal operation of the switch.

To place the CS1768, or to stack units if you are cascading them, remove the

backing material from the bottom of the rubber feet that came with this

package, and stick them onto the bottom panel at the corners, as shown in the

diagram, below:

Table of Contents