ATEN kh2508a User Manual page 19

No. Component
1 Power Socket
2 Power Switch
3 Daisy Chain
Ports
4 Grounding
Terminal
5 Console 1
Ports
6 Console 2
Ports
7 KVM Port
Section
The power cord to the AC source plugs in here.
This is a standard rocker switch that powers the KH2508
KH2516 on and off.
A
When daisy chaining units (see KVM Adapter Cable
Installation Diagrams cont., page 17), the daisy chain cables
plug in here. The port on the left is the Chain In port; the port
on the right is the Chain Out port.
The wire used to ground the unit connects here.
The KH2508 / KH2516
A
consoles. If this is a single station installation, or if this is the
first station of a daisy chained installation, the keyboard,
monitor, and mouse that make up Local Console 1 plug into
section no. 5 and Local Console 2 plugs into section no. 6.
You can use any combination of PS/2 and USB keyboards
and mice for the console.
The Cat 5e/6 cables that link to the KVM adapter cables
(which link to the computers) plug in here.
Chapter 1. Introduction
Description
supports two independent
A
/
A
9