Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted or you have forgotten it, for
example) you can clear the login information with the following procedure:
1. Power off the KH2508
2. Short the jumper labeled J13.
3. Power on the switch.
The on screen display will show a message informing you that the
password information has been cleared.
4. Power off the switch.
5. Remove the jumper cap from J13.
6. Close the housing and start the KH2508
After you start back up, you can use the default Username and Password (see
OSD Overview, page 25) to log in.
/ KH2516
and remove its housing.
A
A
A
/ KH2516
back up.
A
Appendix
75