Upgrade Failed; Firmware Upgrade Recovery; Main Board And Osd Firmware Upgrade Recovery - ATEN kh2508a User Manual

Upgrade Failed

If the upgrade failed to complete successfully a dialog box appears asking if you
want to retry. Click Yes to retry. If you click No, the Upgrade Failed screen
appears similar to below:
Click Cancel to close the Firmware Upgrade Utility. See the next section,
Firmware Upgrade Recovery, for how to proceed.

Firmware Upgrade Recovery

Should the firmware on the switch be missing or corrupted it may not be
possible to operate or boot the switch. This could be due to:
Starting the Firmware Upgrade mode (see FIRMWARE UPGRADE,
page 35), and then canceling the upgrade.
An interruption of the firmware upgrade.
The firmware upgrade procedure failing.
The unit's firmware becoming corrupted for unknown reasons.

Main Board and OSD Firmware Upgrade Recovery

To perform a firmware upgrade recovery, do the following:
1. On the KVM Switch slide the Firmware Upgrade Recovery Switch (see
page 7) to the Recover position.
2. Power off and restart the switch according to the instructions given in the
Powering Off and Restarting section (see page 23).
Chapter 7. The Firmware Upgrade Utility
59